The versatility of Pneumatic high stress grouting pumps

Peumatic Grouting pump is designed for strain and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes in order to reinforce the unfastened rock mass. The maximum grain dimension can not exceed 0.2 mm.
Grouting pump operation and upkeep is easy, secure and dependable. This pump is used in mines working beneath troublesome conditions as a end result of it is dependable and explosion-proof.
Basic Pneumatic Grouting pump include: An air inlet, the pneumatic cylinder, mounting base frame and stand, pressure gauge, pumping cylinder, outlet with quick release coupling and wheels.
How it works

Pneumatic strain within the air cylinder exerts a high strain on the grout mixture which ends up in ejection of grout with a high strain and velocity. The valves of the air cylinder within the pump function routinely to actuate the cylinder. The pneumatic cylinder then moves the plunger up and down to complete the pumping cycle.
Pneumatic grout pump can be pushed even without Electrical energy provide in remote areas through the use of engine driven compressor.

The pump is majorly used in construction and mining industry for injecting materials into broad and medium dimension hole in beams, columns ,basement partitions and flooring, lift shaft concrete wall fill-up etc. In mining เกจแรงดันสูง is used to replenish cement solution the place there is a hole exists between construction and rock and for soil stabilization.
Detachable design tends to straightforward maintenance and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work

This pump is widely used in tunnels, coal mine, bridges and dams, constructing basis, and different underground projects, and inflammable, explosive sites and other dangerous environment.
It has software in chemical business also to pump out chemical slurries.
The pump is electricity free so, can be used at any site condition whether it is rural or urban.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment range. Generally the final amount of the grouting volume is 8 or10 occasions of the amount to begin with. And the final grouting quantity proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s pressure and flow can be adjusted according to the necessities of grouting,(The flow of grouting pump is 0-100L/min, strain of discharge is 0-10MPa).besides, This Pneumatic high-pressure grouting pump can be utilized for grouting single or double fluid.
High-pressure grouting pump is mainly used for highways, railways, water and electricity, development, mining and so forth. ground/underground development.

Mining Pneumatic Grouting pump has some nice benefits of low power consumption, small vibration, low noise, small dimension, excessive effectivity, dependable performance, stress and flow management, lengthy life and so on. Common mine grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can also be Light weight and with a wheelie design it could be carried simply. It is designed for easy operation and low upkeep. Last but not least its spare elements are easily obtainable.

Leave a Comment